It was tested with a DyzeXtruder Pro with a DyzEnd Pro, but it should work for The DyzeXtruder GT as well.
The probe mount is a completely separate part. This design leaves two left-most screws available for use, so you have a lot of options for mounting your probe.
Print in a high-temp plastic such as Polycarbonate for best results.
4x M3 x 14 (M3 X 16 should work too if you have some m3 washers)
2x M3 x 4
2x M3 Heat set inserts (~5mm OD, ~3mm depth)