A reversible case/cover for the Retroid Pocket 2. Primarily for protecting face and stick from pocket debris. It is just over 150mm wide, yet fits diagonally inside a 120mm square build area! Prints fine without supports.
To remove the Retroid Pocket 2 from the case, place your fingers over the top on each side, and push through the bottom with both thumbs.
https://youtu.be/WhDYdC1iJoQ
To remove the Retroid Pocket 2 from the case, place your fingers over the top on each side, and push through the bottom with both thumbs.
https://youtu.be/WhDYdC1iJoQ
